The Dart 250 Series offers superb flexibility, reliability, and value. A general purpose, economical
control rated to 2 horsepower, it provides the ultimate in standard features and versatility including:
Dual voltage (120/240 VAC), adjustable H.P. settings, packaged power bridge, barrier
terminal strip, fully rated, no auxiliary heatsink required, and chassis or NEMA 4/12 enclosure.
Many options further extend the 250's capabilities. A logical, easily accessible layout simplifies installation and
adjustment. Clean design, quality components and careful assembly are trademarks of Dart Controls. |
- Manufactured by Dart Controls
- Dual voltage - 120/240 VAC, 50/60Hz
- Available in chassis or NEMA 4/12 enclosed (washdown duty)
- Adjustable horsepower settings
- Barrier terminal strip
- Packaged bridge supply (fullwave)
- 1% speed regulation with armature voltage feedback;
- ±1/2% with tach feedback
- Adjustable Minimum speed (0–30% of max)
- Adjustable Maximum speed (66–110% of base)
- Adjustable IR Compensation
- Adjustable Linear Acceleration (0.5-8 sec.)
- Adjustable Current Limit to 15 Amps
- Line voltage compensation
- 5K ohm speed potentiometer with leads, knob and dial included
- Power on/off switch (enclosed models)
- 50:1 speed range
- Overload capacity: 150% for one minute
- Transient voltage protection
- Voltage following mode or DC tachometer follower by supplying ungrounded analog input signal (0–12 VDC)
- DC tachometer feedback (6V at base speed)
- Inhibit circuit - permits start & stop without breaking AC lines
- Remote start/stop via pot circuit or inhibit circuit
- Shunt field supply provided (1 Amp max; 100V for 120 VAC; 200V for 240 VAC input)
- AC line fuse
- Enclosed models rated NEMA 4/12 w/threaded conduit holes
- cULus listed - file #E78180
- Note: If you are looking to replace the Dart 125DVE series we recommend the 253G-200E.
|
